Pet Wash Tap Setup — Outdoor Dog Rinse Tap Install in Middlesbrough

Quick answer: The Pet Wash Tap Setup is a proper outdoor rinse-point install — sited in the right place, weather-rated, hose-ready, and optionally hot-and-cold so you can warm-rinse a wet dog without dragging mud through the house.

What it solves

Dogs come back from a winter walk caked in mud. The kitchen sink isn’t built for that. The garden hose is freezing cold and somewhere in the shed. So the dog comes inside, the floor takes the hit, and the towels never recover.

The Pet Wash Tap is the simple version of “fix this properly.” A tap fitted exactly where you want it — back garden, side passage, dog run — with a tidy finish and the right fittings to be useful, not just present.

How we set it up

We pick the spot with you. Where the dog actually comes back to. Where the run is. Where the hose actually reaches without being a trip hazard.
Cold-only or hot-and-cold. Cold-only is the simple, clean install. Hot-and-cold means a mixed warm rinse — a much friendlier experience for the dog and a much faster clean-up.
Hose-ready connector. Standard fitting so you can run any hose, jet attachment, or rinse head off it.
Frost-protected isolation valve. So you can shut it off and drain it before winter — no burst-pipe drama come February.
Weather-rated finish. No exposed copper, no rough boxing-in. Looks like it was meant to be there.

Optional upgrades

Mixer for warm rinses — properly comfortable for the dog, much quicker clean-up
Drainage tray or rinse area — paving slab, gravel run, or a small grated tray so the rinse water has somewhere to go
Tucked-away routing — boxed pipework, neutral colour, hidden behind planting

Frequently asked questions

Can you fit one to a flat or terraced house?

Yes — back walls, side returns, courtyard properties, and rear access yards all work. We’ll pick the closest sensible point to the existing supply to keep the install tidy.

What about freezing in winter?

Every install includes a frost-isolation valve inside the house. One tap-turn drains the outdoor run before a hard freeze. Standard practice — it’s the bit a lot of cheap installs skip.

Will it ruin the look of the wall?

No. The finish is the bit we care about. Tidy boxing, weather-rated tap, neutral colour. We’d rather take an extra hour and have you not notice it than rush it.

Can it double as a general garden tap?

Absolutely. It’s still a real outdoor tap — you can run a hose, fill a watering can, wash the car. The “pet wash” framing is about specifying the right height, fittings, and rinse setup for a dog. Everything else still works.

How long does the install take?

A standard cold-only install is usually a half-day. Hot-and-cold, mixer, or longer pipe runs can stretch into a full day. We’ll quote properly before booking.